Another DIY, challenge?

Discussion in 'DIY' started by xcaret, Sep 5, 2017.

  1. xcaret

    xcaret Supporting Member

    I can leave it with you or Boun, have no rush at all. I'll contact Boun.
    Thanks
     
  2. xcaret

    xcaret Supporting Member

    Is just a tray to place the CaRx on and jusyt in case of a leak, prevent it from spilling on the floor
     
  3. scuzy

    scuzy Supporting Member

    Mario looks like premium Aquatics running a promo on that vertex v6 pump. It looks very similar to that skimmer block for your vertex alpha. Could you get that and put a pin wheel in?
     
  4. xcaret

    xcaret Supporting Member

    I'll check into that. I think if I cannot get a pin wheel, will use Enkamat, have plenty of that stuff. Found a few pinwheels at home but they are for Sicce and ER skimmers, there's gotta be a way to attach them to the impeller.
    Gave the volute to Ian this day, he's going to scan a 3D file to have it 3D printed; a BIG THANKS to Ian
     
  5. xcaret

    xcaret Supporting Member

    That would be awesome !
     

Share This Page