Kessil

Anybody using a Neptune WXM with Ecosmart modes?

Having problems with my WXM and my MP40ES. When the pumps run in NTM the pumps just rev like when you are programming the speed with the drivers. It works fine tidal and lagoon modes but I'd like to use NTM mode most of the time. My MP40ES drivers are up to date (1.5) and my Neptune firmware is the latest (4.03L_6A10).
 
I use the WXM and NTM mode. Not sure I understand the question, but when in NTM it will use the last programed pulse mode for the surge effect of the NTM. I wish there was a better way to program the pulse mode for NTM.
 
Thanks for the quick response Greg!

You know when you originally setup your pump without the WXM and you were using the ES driver and you set the speed of your NTM it would do a revving action? The pump would slow down and speed up depending on where you set the dial and the LED's would also light showing you max speed? Well that's what my MP40's are doing when they are in NTM. It doesn't run in NTM correctly.

Here is my code:

(MP40Left)
Set NTMMax
If Time 06:51 to 09:00 Then LagnMin
If Time 09:01 to 12:30 Then TidalMin
If Time 20:00 to 21:00 Then LagnMin
If Time 21:00 to 06:50 Then Night
If FeedA 000 Then FeedMode
If FeedD 000 Then OFF

(MP40Right)
Set OFF
If Outlet MP40Left = ON Then Sync

When it's in NTM mode it's basically acting like I'm still setting up the speed.

http://www.youtube.com/watch?v=fbd35f251mM
 
Sorry, you got me, try resetting the MP controller and clearing the memory? I had to do that a few times to get mine working but not sure if its the same issue you are having. I had a good experience with vortech's support, try giving them a call, or maybe neptune systems.
 
Here's a video of my pump running in NTM with the WXM. Is this normal?

http://www.youtube.com/watch?v=c9bO7AJppro

When I was just running the ES drivers it was not like this. Unless I was running in Tidal mode the whole time..............
 
Back
Top