Big tube for clownfish slide

Discussion in 'Equipment' started by Gablami, Apr 21, 2017.

  1. Gablami

    Gablami Supporting Member

    Does anyone have something like this or have a good suggestion for where to get one?

    Has any tried this technique?




    Sent from my iPhone using Tapatalk
     
  2. Bruce Spiegelman

    Bruce Spiegelman Supporting Member

    Tap plastics?
     
    Coral reefer likes this.
  3. xcaret

    xcaret Supporting Member

    TAP plastics should have some clear cylinder, not the pricey acrylic.
     
  4. Gablami

    Gablami Supporting Member

    Checked their website. 3 ft tube of 12 in diameter acrylic is $450!! Ouch.


    Sent from my iPhone using Tapatalk
     
  5. RandyC

    RandyC Supporting Member

  6. Bruce Spiegelman

    Bruce Spiegelman Supporting Member

    Actually I have some! Bat holders. They run about $10.00 or if you're near me I can give you one.
    SPCA291.JPG
     
    California_Reef_Co likes this.
  7. Kensington Reefer

    Kensington Reefer Supporting Member

  8. Gablami

    Gablami Supporting Member

    Hmm good idea! Walnut Creek is a little outta the way for me. I can get one on my own I think. It also occurred to be that I can use my old skimmer body around the nem and just slide the clowns into the skimmer body. I'll take a video one day if this actually happens.


    Sent from my iPhone using Tapatalk
     
  9. Bruce Spiegelman

    Bruce Spiegelman Supporting Member

    You can buy them at any sports card or memorabilia store.
     
  10. Flagg37

    Flagg37 Officer at large

    12" diameter is huge. They didn't have anything smaller? PETG would be cheaper than acrylic too.
     

Share This Page