DC Power Supply Question

Discussion in 'Equipment' started by Wlachnit, Apr 30, 2019.

  1. Wlachnit

    Wlachnit BOD

    Can I use a 24v, 4.0A power supply on an Ecotech MP40 which only requires a 24v, 2.5A power supply? If memory serves me, it should be fine, correct?
  2. rygh

    rygh BOD


    Are you using old connector? That is often something that does not match well.
  3. Wlachnit

    Wlachnit BOD

    Thanks. It's a standard 5.5x2.5mm connector.
  4. sfsuphysics

    sfsuphysics Supporting Member

    The upside is you can always splice in the older connector, just be careful of polarity

    This symbol will tell you if the outer part is positive or negative charged

Share This Page