Metric size pvc pipes and fittings

Discussion in 'Equipment' started by Edgar Sandoval, Feb 10, 2017.

  1. Edgar Sandoval

    Edgar Sandoval Supporting Member

    Do you guys know if any local hardware stores or fish stores carry metros size pvc parts? I need 32mm elbows and 40mm elbows.


    Sent from my iPhone using Tapatalk
     
  2. I ran in the same problem, I couldn't find metric pvc anywhere. If your in a rush you can use a piece of tubing to adapt from metric to standard. If not your best bet is to order it.
     
  3. Flagg37

    Flagg37 Officer at large

    Yeah, metric plumbing is hard to find.
     
  4. scuzy

    scuzy Supporting Member

    Best to get the metric converted fittings from brs.


    Sent from my iPhone using Tapatalk
     
  5. scuzy

    scuzy Supporting Member

    Or dremel the size down. Since it's not pressure fittings you can sand it down a bit.


    Sent from my iPhone using Tapatalk
     
  6. Flagg37

    Flagg37 Officer at large

    The 32mm (1.2598") is super close to 1-1/4". 40mm (1.5748") is a bit further off from 1-1/2".
     
  7. xcaret

    xcaret Supporting Member

    I believe Ryan Herco in SJ? has metric; I'm on the same boat but in no rush to fix a Korallin reactor
     
  8. Julius Chen

    Julius Chen Supporting Member

    I use teflon tape to bridge the slight gap
     

Share This Page