sfsuphysics's Recent Activity

  1. sfsuphysics replied to the thread My 210 restart..

    That should be fine, those carbon blocks are the big unknown of the situation. RO membrane, you can have a TDS meter before and after...

    Oct 18, 2018 at 1:56 PM
  2. sfsuphysics replied to the thread My 210 restart..

    Yes, but not for the reasons you think. I seem to recall that DI resin will take care of chloramine so if you read zero TDS your resin...

    Oct 17, 2018 at 9:55 PM
  3. sfsuphysics replied to the thread FS Green Gecko Acro.

    Damn Bob, why can't you wait until I get my tank up! ... so like sometime next year Easter :D

    Oct 17, 2018 at 8:26 PM
  4. sfsuphysics replied to the thread Uh oh, should I move the acan?.

    The part that is touching, yeah those polyps are 100% going to die. The polyps that don't touch the anemone, not going to die... at...

    Oct 17, 2018 at 7:31 PM
  5. sfsuphysics replied to the thread Mike's Last Build.

    None of it goes against a wall, it is in its final space. All but the left side can be accessed

    Oct 17, 2018 at 3:02 PM
  6. sfsuphysics replied to the thread If you could only have 1 acro.

    Nice millepora could be good for a unispecimen tank, grow, frag and reglue over your rock. Milles can branch or fuse together in a...

    Oct 16, 2018 at 9:10 PM
  7. sfsuphysics replied to the thread CDA 87G.

    Gotta say that picture of the Palmer's blue doesn't scream out to me as a millepora, the later one kind of does... but hard to tell with...

    Oct 16, 2018 at 8:14 PM
  8. sfsuphysics replied to the thread Rygh's 250 gallon - Rev 3.

    What did you have on those relay ports? I found that putting heaters on controller ports if the heaters are anywhere larger than 300W...

    Oct 16, 2018 at 8:10 PM
  9. sfsuphysics replied to the thread Mike's Last Build.

    Well there's 3 basic areas, 2 - 1' x 2' sections, and 1 - 2' x 4' section approximately, the inside dimensions are a few inches...

    Oct 16, 2018 at 8:06 PM
  10. sfsuphysics replied to the thread Rygh's 250 gallon - Rev 3.

    Sounds like you shouldn't have disconnected the salinity probe then.

    Oct 16, 2018 at 6:04 PM
  11. sfsuphysics replied to the thread Mike's Last Build.

    Did the last bits of cutting today, and slid it all together. Need to glue it together, and fill a couple holes, and get some trim...

    Oct 16, 2018 at 5:29 PM
  12. sfsuphysics replied to the thread Extra Blue Eye Cardinals from order (today) and Mocha Clowns from Macna.

    Well since you have others who are jumping on this "sight unseen" I'll bow out of my request... would love them, but in the grand scheme...

    Oct 16, 2018 at 3:58 PM
  13. sfsuphysics replied to the thread Regional Swap - What are you bringing?.

    Strangely enough, same stuff I brought last year, searching back through photos here's one from a year ago. Here's an old picture,...

    Oct 15, 2018 at 11:31 PM
  14. sfsuphysics replied to the thread Extra Blue Eye Cardinals from order (today) and Mocha Clowns from Macna.

    What type of blue eye are they? Stripped ones? Silver/gray ones? Also how blue are the blue eyes? Are these something that mature...

    Oct 15, 2018 at 11:25 PM
  15. sfsuphysics replied to the thread Faster growing frags? Suspended frags? Micro frags?.

    Gonna have to disagree here with the idea that corals double in size within a fixed set time period. Sure their growth might not...

    Oct 15, 2018 at 5:11 PM