RandyC's latest activity

This is not correct. No gasket is needed in the external overflow box. Gasket in tank between flange and glass and gasket between...

The box is made specifically made with that offset on the top of the box to accommodate tanks with trim. Did you try different...

I have chaetogro on a Versa doser sitting on a magnetic stirrer. Stirrer turns on a couple minutes before dosing. If you're going to...

Slight chips are not bad. Chips that will need silicon are ones where the gasket does not have enough completely flat surface area to...

A gasket sheet really shouldn't be any better than a gasket ring. The seal comes as the compression of the gasket forming a seal from...

I've been through more modular marine overflows than I can count. Here's some general suggestions. 1. You should only need a bulkhead...

Unfortunately, I'm not able to attend, but I'm sure it'd be interesting to hear their take on antibiotics in the industry, both for home...

It won't kill flow per-say. The same amount of water will go into the pipe, it will will eventually run at a slower velocity. That can...

Non-acro 4K HDR vid: https://photos.app.goo.gl/dHpp3MXCxUGxTE666 Redid the lid with polycarbonate:

Easy peasy. I think I drained at least halfway if not more. Also, I had no rock or sand in the tank at the time

Air shims are money btw! Love 'em. I used them for my 150 gallon. Post in thread 'Randy’s Flock o' Reef Tanks'...

I would suggest composite shims and not wood shims. Wood shims will expand and then eventually deteriorate if (when) water gets on them...

Of course using cured, seeded and cycled rock will allow you to set up a tank faster. Have enough of it and you can have a fully loaded...

You're asking for trouble. Get rid of that bendy stuff and epoxy. Recipe for another leak if you lean on that flexible drain wrong that...

Two years?!?!? Are you aging some fancy expensive cheese in there?