Search results

Thanks, I’ll look into that.

Hello Any recommendations for a sandblasting place in the peninsula? I need to get surface rust off of my wire wheels after 15 years of being neglected. Thx

Spaghetti worm?

When I look at the images of your tank, a Prismacolor box set comes to mind...

At first I had a hard time because I wanted it to be a perfect seam but gave up. Ran the brush along the edge with plenty of solvent/glue (gray); worked the bottom and opposite sides, then I bonded the other two pieces. Keeping them upright was the most challenging part but some full soda cans...

I made a “tub” out of PVC sheet from TAP Plastics; I believe it was 1/4” It’s in the cube cabinet at Seven Stills; maybe @Tim Obert can snap a picture of it?

you're the highest bidder. When you'd like to pick it up?

Summer's around the bend...

Thx, I’m looking into products for hard to reach-next-to-impossible places. Inside bottom of the doors have rust. I’m gonna try my luck at polishing some pot metal pieces. Bumpers have surface rust and I’m using a flap wheel to remove it. Have to start a piggy bank so I can have at least the big...

I'm working on a little project at home, in the garage area... Been disconnected from and neglected my little ride for years now and want to give it the attention it requires. I know for quite some time of Por15 to be used to "neutralize" surface rust. There's also Rust Mort and some others on...

VHO's !! That means you're old school Welcome back !

Nice 1/4hp chiller for any supporting member; not a supporting member? No problem, become one and is yours. Sold this chiller to a person on RC a while back; he claimed it had a leak but the fittings are conical and doesn’t have O-rings. Seems he used a wrench to try and tighten the plastic nuts...

Right. Rich posted some useful info for me to relay to the medical personnel at the hospital.

For some LPS dominant systems and for non-photosynthesis corals, I recall people doing a broadcast feeding time. The issue with targeted feeding is fish going for the food.

Last week I went to Pick N Pull with my brother and son to get some parts for my brother's Golf. While they were looking for the parts, I saw a nice set of BBS two-piece wheels with decent tires that were still mounted on a Jetta but they had the wheel locking stud. I knew my son has the proper...

I had a similar issue a while back with a cube; I used Bar Keepers Friend? What did the trick was polishing using cerium oxide.

I might stop by HD tomorrow, in the event they still have it, Do you want me to get one for you?

Mixing your water is an easy task; there are different salt mixes available but you’ll need an RODI unit. Depending if you own or rent, possibilities could be endless or limited. Here you’ll find the best info and the best-est people to help you walk to a beautiful piece of ocean.

Maybe show them the picture I posted see if they can give you the same price as Colma