gmdcdvm
Supporting Member
I had purchased a clearview lid about 3-4 years ago for my waterbox 60g tank. At the time I wasn’t sure if I wanted the lid frame to be a single piece or a modular design made up of four interconnected pieces. Ended up going with the modular design since it was cheaper.
Fast forward 3-4 years later and I wanted to add an Avast plank feeder to the tank. I emailed them to see if this was an option. They said the design of my lid was an older version but they had my lid on file. So, I just sent them my request of which section I wanted to replace and where I wanted the feeder. I also asked for a cover/door in case I take the feeder off for any reasons.
They were able to make it happen. Got the new section in the mail. Took a little bit to remove the old section and put the new one in but it worked out well.
Fast forward 3-4 years later and I wanted to add an Avast plank feeder to the tank. I emailed them to see if this was an option. They said the design of my lid was an older version but they had my lid on file. So, I just sent them my request of which section I wanted to replace and where I wanted the feeder. I also asked for a cover/door in case I take the feeder off for any reasons.
They were able to make it happen. Got the new section in the mail. Took a little bit to remove the old section and put the new one in but it worked out well.
