It's a wet-dry bandsaw. there is a water flow accessory. Very little of the wet area can rust. Just clean it and flush with FW after use, then dry. There is one rustable bearing that you just need to keep lubed
[quote author=Gomer link=topic=6713.msg86783#msg86783 date=1236363607]
It's a wet-dry bandsaw. there is a water flow accessory. Very little of the wet area can rust. Just clean it and flush with FW after use, then dry. There is one rustable bearing that you just need to keep lubed
[/quote]
The club should buy one of these and bring it to every meeting...
This band saw is good for light duty. Every time its been used for more than just a few cuts I get scarred that its going to break on me. The problem is the motor over heats and I've actually had to send it in once to get it repaired. It was under warranty however it was a lot to ship (I made the mistake of taking it to the UPS store to ship).