Murlock for BRS reactor silicone tubing

Discussion in 'Equipment' started by Jeff Rehling, Nov 21, 2018.

  1. Jeff Rehling

    Jeff Rehling Supporting Member

    Joined:
    Aug 5, 2016
    Messages:
    846
    Likes Received:
    62
    I bought the silicone tubing upgrade for my BRS reactor, but I have a dual reactor, which requires three of these. Anywhere on the SF side of the bridge carry these?
     
  2. Vhuang168

    Vhuang168 Supporting Member

    Joined:
    Mar 2, 2015
    Messages:
    3,218
    Likes Received:
    960
  3. Jeff Rehling

    Jeff Rehling Supporting Member

    Joined:
    Aug 5, 2016
    Messages:
    846
    Likes Received:
    62
    yes, you are correct; it is soft. I have three connectors. One goes into each of the in/out holes on the reactor. The third connects to the pump. The question is, i also have the gray valve assembly that controls the flow to the GFO reactor. I would need two more then, yes?

    Does anyone sell them in SF? I would like to get my reactor running again
     
  4. Jeff Rehling

    Jeff Rehling Supporting Member

    Joined:
    Aug 5, 2016
    Messages:
    846
    Likes Received:
    62
    This guy...i'm sure i need the connectors for each end
     

    Attached Files:

  5. Vhuang168

    Vhuang168 Supporting Member

    Joined:
    Mar 2, 2015
    Messages:
    3,218
    Likes Received:
    960
    If the tubing works in the connectors on the reactors, they should work on the connectors for the ball valve.
     
  6. Jeff Rehling

    Jeff Rehling Supporting Member

    Joined:
    Aug 5, 2016
    Messages:
    846
    Likes Received:
    62
    i'm under the understanding that the push connectors won't function with the silicon
     
  7. Vhuang168

    Vhuang168 Supporting Member

    Joined:
    Mar 2, 2015
    Messages:
    3,218
    Likes Received:
    960
    How did you connect the tubing to the reactors?
     
  8. Jeff Rehling

    Jeff Rehling Supporting Member

    Joined:
    Aug 5, 2016
    Messages:
    846
    Likes Received:
    62
    Good question, and I haven't been clear. I was running the dual reactor with the original stiff tubing. I bought the upgrade kit with the soft tubing, but can't use it without the Mur-lok adaptors. The stiff tubing works in the push connectors
     
  9. Klems

    Klems Supporting Member

    Joined:
    Jun 29, 2015
    Messages:
    459
    Likes Received:
    97
    You need to order the mu IMG_20181121_154905182.jpg rloc to barbed fitting from BRS...nothing local that I've seen.
     
  10. Jeff Rehling

    Jeff Rehling Supporting Member

    Joined:
    Aug 5, 2016
    Messages:
    846
    Likes Received:
    62
    yep ordered them today. stupid BRS doesn't offer an option for the dual reactor
     

Share This Page