Neptune Apex alerts set up

[gmdcdvm]

I have been looking at some online videos trying to figure out how to set up alerts on my Neptune Apex. I am hoping for those of you with more experience can help me out. I am trying to get more familiar with the trident, but I have to admit the whole coding thing is a pain and a bit confusing. I would like to receive more alerts.
Right now, I get an alert when my top off water level is too low or high. I get alerts from the Trident about if my Ca, Alk, or Mg parameters are out of range.
I would like to get alerts when other things go wrong with the trident such as low reagents, waste is full, no sample line, etc. I can see these when I log into the app, but I do not get alerts for these.
Are there other alert set ups you would recommend?
Thanks
Gerry

 

[L/B Block]

This one covers any issue with trident:
If Error Trident_6_3 Then ON


I use the same code except swap out trident with apex for any apex issues such as disconnects and the same for the COR pump for any issues related to return pump.

 

[gmdcdvm]

Where do you add this code?

 

[L/B Block]

In the alarm settings. Alarm settings should be already in the dashboard already

 

[gmdcdvm]

This one covers any issue with trident:
If Error Trident_6_3 Then ON


I use the same code except swap out trident with apex for any apex issues such as disconnects and the same for the COR pump for any issues related to return pump.

When I changed the Trident testing schedule the numbers were determine by the module address for the Trident. In my particular system the Trident address is 3.
Is the _6_3 specific to your system or can this be used by anyone?

Gerry

 

[L/B Block]

The _6_3 is my system.,
Once you start typing in
If error
Then once you start typing Tri… (spelling & capitalization matters) the trident module should just pop up as an option - and you should be good to go.

 

[FinalPhaze987]

How i have mine set up:

Click the gear icon on your alerts:

My configuration is as follows

The names of your modules and locations may be different, but as stated above, once you start typing it they should populate