Hey everybody yesterday I bought a phosban 550 media reactor and was very eager to hook it up. I’m using it as a chaeto reactor so I got it all set up and it’s working and pumping fine but my mp1200 pump pumps at a higher rate than what is recommended in the instruction manual for the Phosban 550 reactor. About twice as fast. I realized I didn’t set up the ball valve that controls the flow rate, I just have the two tubes going in and out. I’m only using chaeto and not GFO or any other stuff in there that needs tumbling so I was wondering do I need to go back in here and install the ball valve or what I’d be OK just leaving it as is.
Pics are hard to see hit you see just the tubing and not ball valve installed.
The rate is fast and the chaeto is pushed up and stays up. No tumbling
Help
Sent from my iPhone using Tapatalk
Pics are hard to see hit you see just the tubing and not ball valve installed.
The rate is fast and the chaeto is pushed up and stays up. No tumbling
Help
Sent from my iPhone using Tapatalk