Cali Kid Corals

Lets see your TV arm mount to light rail

It’s very simple. It’s just an electronic standing desk. You can get one on fb marketplace for free. The two motor one is better that the single if your lights are super heavy.
Anyways. Just remove the desk top. Drill out the end holes. I used ecotech rms light rail cuz I had it but anything will work. I chopped the legs off and welded a two T legs. I can weld it for you if you need. Ran an extension cable for the controller. That it.
image.jpg
 
Turkeysammich said:
It’s very simple. It’s just an electronic standing desk. You can get one on fb marketplace for free. The two motor one is better that the single if your lights are super heavy.
Anyways. Just remove the desk top. Drill out the end holes. I used ecotech rms light rail cuz I had it but anything will work. I chopped the legs off and welded a two T legs. I can weld it for you if you need. Ran an extension cable for the controller. That it.
Click to expand...

Nice set up! I wanted to do something similar for my Elos tank build, but using only one of the dual motor leg. Found out both legs need to be plugged for it to function tho.
 
Turkeysammich said:
It’s very simple. It’s just an electronic standing desk. You can get one on fb marketplace for free. The two motor one is better that the single if your lights are super heavy.
Anyways. Just remove the desk top. Drill out the end holes. I used ecotech rms light rail cuz I had it but anything will work. I chopped the legs off and welded a two T legs. I can weld it for you if you need. Ran an extension cable for the controller. That it. View attachment 69509
Click to expand...
Cant see sheet
 
SupraSaltyReefer said:
@CaseyP probably has the best TV mount light rack I've seen: https://www.bareefers.org/forum/threads/caseys-red-sea-s-1000.33335/post-484431
Click to expand...
The only downside is that I cannot move it up and down, only back and forth, so you have to get it right the first time mounting to the wall, or hang the lights from the rail so they're adjustable. If this was a smaller lighter setup, I would've considered the monitor arms that use a gas piston to move up and down.
 
CaseyP said:
The only downside is that I cannot move it up and down, only back and forth, so you have to get it right the first time mounting to the wall, or hang the lights from the rail so they're adjustable. If this was a smaller lighter setup, I would've considered the monitor arms that use a gas piston to move up and down.
Click to expand...
With that I'd imagine it would be hard to get the light pointed horizontal and hold really any weight at all.
 
You must log in or register to reply here.
Back
Top