RODI to Soft Tubing Connector Calcium Reactor

[Baykes]

Recently picked up a Geo618 and Kamoer FX-STP and am looking to set it up in the next couple of weeks. The Geo has hard RODI line tubing whereas the kamoer has nipples for a soft type tubing. What kind of connector can I use?

 

[CaseyP]

I use a 3/16" barb to 1/4" push connector. Barb end connected to the Kamoer soft tubing and 1/4 push going into an shut-off coupler. From there you can connect rigid tubing to your reactor.

 

[Baykes]

Awesome thanks!

 

[Turkeysammich]

Daymn. Fancy. I just shove the hard line into the soft line and zip tie it. Lol. Ghetto Fabulous.

 

[iani]

Daymn. Fancy. I just shove the hard line into the soft line and zip tie it. Lol. Ghetto Fabulous.

This is what I do.

 

[finalphaze987]

Not sure where your located, but i got a few I can spare if you need. I'm in Hayward.

 

[richiev]

Daymn. Fancy. I just shove the hard line into the soft line and zip tie it. Lol. Ghetto Fabulous.

This is 100% what I do, but now I'm going to find equivalent connectors to 3d print.

 

[iani]

This is 100% what I do, but now I'm going to find equivalent connectors to 3d print.

With any connector you do create a constriction point. Not sure if this matters to anyone.