DIY Wood Stand or Aluminum Stand?

[ashburn2k]

Structurally, the stand is complete. I made the cutouts for the bottom panel and it wasn’t too pretty since I tried to do it with a miter saw so I’m going to get some 1x2s tomorrow and cut them to border the bottom of the stand like in the pic with the example 2x4s that way there’s no gaps for stuff to fall into. I have a jig saw and router coming in tomorrow so I can do the doors

use a cardboard for cutout so you can trace it on plywood

 

[MarcosD]

This is practically done besides the painting. I just need to get a few more screws to mount the bottom magnets for the door. I mount the top two and then ran out so the door is a little wonky right now