I need some help with my rodi system. I'm getting much lower pressure before my RO membranes based on inline pressure gauge. I have the 6 stage deluxe brs system. I added a chloramine monster after the carbon blocks so it is setup as:
1 micron sediment filter --> 1 micron carbon block --> 1 micron carbon block --> chloramine monster --> RO (x2 for 150g/d) --> dual DI canisters.
There is an auto shut off float valve installed.
Before this problem I could easily get pressures in the 80-100 psi range (attached to an outdoor hose bib that seems to high water pressure, no booster). Now I can barely top 20 psi.
I first bypassed the chloramine monster to see if that was the problem, and that didn't solve anything. I then switched out my sediment filter to a brand new filter. That also didn't change anything.
So I'm not sure what to do next. Should I take out my filters one by one to see where the hangup is? Could my pressure gauge be busted? Is my float valve auto shut off messing with things?
Sent from my iPhone using Tapatalk
1 micron sediment filter --> 1 micron carbon block --> 1 micron carbon block --> chloramine monster --> RO (x2 for 150g/d) --> dual DI canisters.
There is an auto shut off float valve installed.
Before this problem I could easily get pressures in the 80-100 psi range (attached to an outdoor hose bib that seems to high water pressure, no booster). Now I can barely top 20 psi.
I first bypassed the chloramine monster to see if that was the problem, and that didn't solve anything. I then switched out my sediment filter to a brand new filter. That also didn't change anything.
So I'm not sure what to do next. Should I take out my filters one by one to see where the hangup is? Could my pressure gauge be busted? Is my float valve auto shut off messing with things?
Sent from my iPhone using Tapatalk